High Speed Triangular Keel Forming Machine

Description：

Unit rolling capacity: width ≤ 200mm,

Sheet thickness 0.6-1.2mm

Production speed: 15-30 m / min

Total installed capacity: about 5.5kw

Production area: length 15 meters X width 2.5 meters

Equipment composition：

The equipment consists of a discharge machine, a guiding frame, a forming host, a calibration device, a cut-off part, a receiving table, and an electrical control part.

The equipment produced by our company has the following advantages:

1. The equipment control is PLC control, and multiple safety protection is set during normal production.

2. The bed is welded with steel plates. It is also tempered to eliminate internal stress and avoid deformation of the fuselage.

3. The forming frame is cast iron structure and tempered. High strength and long service life.

4. The material of the roll shaft is 40Cr, and the hardness is HB280 after quenching and tempering treatment.

5. The material of the forming mold is GCr15, quenching treatment, hardness: HRC 56-62 °C.

6. The transmission structure is gearbox transmission. Each molding frame has a gearbox that guarantees time-out, high-intensity operation and long service life.