The detection part of the chain drive roof panel roll forming machine includes: a pulse encoder for detecting the length of the roof panel, a press-type upper and lower stroke switch, a cutter upper and lower stroke switch, a press-type upper and lower operation button, a cutter upper and lower stroke button, Emergency stop switch, hydraulic start and stop switch and so on. The chain drive roof panel roll forming machine performs part of the inverter drive motor, hydraulic station motor, two hydraulic solenoid valves of the pressure type, and two hydraulic solenoid valves of the cutter.
How do you install these components into a complete chain drive roof roll forming machine? One is the striping or block installation method, which refers to the method of installing the grid frame into strips or block units, which are respectively hoisted by the lifting equipment to the high-altitude design position, and then placed in an integral manner.
Slitting or splicing installation Most of the welding and splicing work is carried out on the ground, which is beneficial to improve the quality of the project and save most of the assembled brackets. Since the splitting unit has already considered the existing lifting equipment capacity on site, it can be fully utilized. Existing equipment at the construction site to reduce the rental fee for lifting equipment.
Another method is the high-altitude bulk method, which is a method of assembling a small unit or a piece directly at a design position. The high-altitude bulk method has two methods: full-support method and cantilever method. The full-support method is mostly used for assembling parts, while the cantilever method is mostly used for small units in high-altitude. Since the parts are assembled at high altitude, there is no need to use large lifting equipment, but due to the large-scale assembly bracket, a large amount of scaffolding materials are required.