Categories
Contact Us
Add: No.586, Xizhang Road, Gushan Town,Jiangyin District, Wuxi City, Jiangsu Province.
Tel: +86-510-86958108
Mob: +8615251570517
Fax:+86-510-86958108
E-mail:jybw@jybangwei.com
Dong zhen wei:+8615995369211
Knowledge
Home > Knowledge > Content
Forming machine operation method
Nov 05, 2018

1. Select the flat surface and stabilize the machine. The chassis feet can be pulled apart to make the machine panel easy to observe.


2. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Pay attention to the positioning gap


3. Plug one end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply.


4. Open the "POWER SW." on the rear panel of the chassis and press the "SWITCHING" button on the panel. When the "WARM UP" green indicator is on, the machine will work.


5. Press and hold the "SETTING BUTTON" button to set the appropriate value, typically between 0.5 and 2.0 seconds.


6. Place the sensor head on the lid of the container and press the start button on the handle. At this time, the "HEATING" red indicator light is on, indicating that it is heating, the sensor head is not removed, and the "HEATING" red indicator light is off. Then remove the sensor head and wait for the "WARM UP" green indicator light or the internal buzzer to beep "beep" to perform the next container sealing operation.


7. Check the sealing quality. According to different materials, diameter containers and production efficiency, properly adjust the "SETTING BUTTON" button to make the sealing quality the best.


  • Newsletter
  • Categories
  • Contact Us
    Add: No.586, Xizhang Road, Gushan Town,Jiangyin District, Wuxi City, Jiangsu Province.
    Tel: +86-510-86958108
    Mob: +8615251570517
    Fax:+86-510-86958108
    E-mail:jybw@jybangwei.com
    Dong zhen wei:+8615995369211
  • QR Code
  • Copyright © Jiangyin Bangwei Machinery Co.,Ltd All Rights Reserved.