Before the rotary rolling guard roller forming machine is commissioned, first check the four corners of the front and rear of the equipment from the height of the upper end of the large frame, and then from the first row to the final row, find a straight line and check it. Whether the lower axis is on a straight line, and the left and right ends of the lower axis are leveled.
Find the middle of the first row and the final row of the rotary rolling guard roll forming machine, then tighten the two locks, pull a straight line in front of and behind the middle wheel, and adjust the gap between the upper and lower shafts. You can adjust the machine along the line. If the board runs to the right, pad the left corner, or the bottom right.
The rotating rolling guardrail roll forming machine has reasonable layout and convenient operation, complete functions, feeding, pressing, dispensing, heating, trimming, slotting and blocking, and is used for steel layout factory housing panels. The equipment uses fine low-speed metering pump, frequency control or stepless speed regulation, computer control, and accurate measurement.